Rear-door rib assembly (duplex product)
NOTE: The duplex fan (FM2) is a component of the rear-door rib assembly.
1. Remove the following components:
●
Right cover. See
Right cover on page 108.
●
Rear-upper cover (duplex products). See
Rear-upper cover (duplex product) on page 111.
●
Rear door (duplex products). See
Rear door (duplex product) on page 106.
●
Rear-lower cover (duplex products). See
Rear-lower cover and rear-door links (duplex
product) on page 116.
2. Disconnect one connector (callout 1).
TIP: The PCA can be dislodged when disconnecting the connector. To secure the PCA, carefully
push it towards the inside of the product to clear the mounting tabs near the rib assembly. Slide
the PCA towards the rib assembly to position the edge of the PCA under the mounting tabs.
Figure 6-60 Remove the rear-door rib assembly (duplex product) (1 of 3)
1
ENWW Components and major assemblies 119
To Next Page
Loading...