DC controller PCA
Special considerations
WARNING! Do not install a replacement formatter PCA and a replacement DC controller PCA at the
same time.
The formatter PCA and the DC controller PCA store important product configuration information
(NVRAM data) that is lost if both PCAs are replaced at the same time. When the product power is turned
on, the formatter restores the NVRAM data to a replacement DC controller.
Replacing both the DC controller and the formatter at the same time will result in severe print-quality
problems.
Replacing the DC controller PCA before the formatter PCA
Use the following procedure if you need to install a replacement DC controller and a replacement
formatter PCA.
NOTE: If you are only installing a replacement DC controller PCA, go to Remove the DC controller
PCA on page 142.
1. Install a replacement DC controller PCA.
2. Turn the product on, and wait for the print-cartridge volume indicators to appear on the control-
panel display.
NOTE: This allows important product information to be written to the replacement DC controller
PCA.
3. Turn the product off.
4. Install a replacement formatter PCA. See
Formatter PCA on page 144.
5. Turn the product on.
Remove the DC controller PCA
CAUTION: Do not bend or fold the flat flexible cables (FFCs) during removal or installation. Also, do
not straighten prefolds in the FFCs. You must ensure that all FFCs are fully seated in their connectors.
Failure to fully seat an FFC into a connector can cause a short circuit in a PCA.
Some parts are sensitive to electrostatic discharge (ESD). Always perform service work at
an ESD-protected workstation or mat. If an ESD workstation or mat is not available, ground yourself by
touching the sheet-metal chassis before touching an ESD-sensitive part.
1. Remove the following components:
●
Right cover. See
Right cover on page 108.
●
Upper cover. See
Upper-cover assembly on page 121.
●
Right panel. See
Right panel on page 136.
142 Chapter 6 Removal and replacement ENWW
To Next Page
Loading...