Fuser motor assembly
1. Remove the following components:
●
Right cover. See
Right cover on page 108.
●
Formatter PCA. See
Formatter PCA on page 144.
●
Rear door (simplex products). See
Rear door (simplex product) on page 104.
●
Rear cover (simplex products). See
Rear cover and feed guide (simplex product)
on page 112.
●
Rear-upper cover (duplex products). See
Rear-upper cover (duplex product) on page 111.
●
Upper-cover assembly. See
Upper-cover assembly on page 121.
●
Control-panel assembly. See
Control-panel assembly on page 124.
●
Right panel. See
Right panel on page 136.
2. Remove four flat-head screws (callout 1), three screws (callout 2), and then remove the sheet-
metal plate.
CAUTION: The four flat-head screws must be installed in the correct position to avoid damage
to the formatter. Standard screws can contact the formatter when it is installed and can cause a
short circuit.
Figure 6-116 Remove the fuser motor assembly (1 of 8)
1
2
154 Chapter 6 Removal and replacement ENWW
To Next Page
Loading...