Output bin 3 lift operation
Figure 1-70 Stapling mailbox sensors for output bin 3 lift operation
M6
SR3
PS2601
PS2602
Stapler/Stacker lifter motor
Output bin 3 higher limit sensor
Output bin 3 lower limit sensor
Output bin 3
media full sensor
Output bin 3
The operational sequence of the output bin 3 lift operation is as follows:
1. The stapler/stacker lifter motor rotates if both the output bin 3 higher limit sensor and the output bin 3
media full sensor are off when the product is turned on until following conditions occur:
●
The output bin 3 higher limit sensor detects the output bin 3.
●
The output bin 3 media full sensor detects paper.
The stapler/stacker lifter motor is reversed if either the output bin 3 higher limit sensor, or the output
bin 3 media full sensor is on, or if both sensors are on when the product is turned on to lower the output
bin 3 to a specified level.
2. When the printed pages are stacked on the output bin 3, and the output bin 3 media full sensor detects
the paper, the stapler/stacker lifter motor is reversed to lower the output bin 3 to a specified level.
3. The stapler/stacker controller notifies the formatter through the DC controller when the output bin 3
media full sensor detects paper. The output bin 3 lowers to the position of the output bin 3 lower limit
sensor.
The stapler/stacker controller determines a stapler/stacker lifter motor failure. The controller notifies the
formatter through the DC controller when it encounters the following conditions after the stapler/stacker
lifter motor starts rotating:
●
Output bin 3 does not reach the output bin 3 higher limit sensor within a specified period of time.
●
The output bin 3 media full sensor does not detect paper
ENWW Stapling mailbox (M680) 95
To Next Page
Loading...