Table 2-7 Pre-boot menu options (7 of 7)
Menu option First level Second level Third level Description
Administrator
(continued)
Remote Admin Start Telnet The Remote Admin item allows a service technician to
access to the product Pre-boot menu remotely, and to
navigate the menu selections from a remote location.
IMPORTANT: A Remote Admin connection must be
initiated by a person that is physically present at the
product.
This person will also need to provide a randomly
generated PIN to the remote service technician.
NOTE: For more information about using the Remote
Admin function, see
Remote Admin on page 115.
Stop Telnet
Refresh IP
System Triage Copy Logs If the device will not boot to the Ready state, or the
diagnostic log feature found in the Troubleshooting
menu is not accessible, then use the System Triage item
to copy the diagnostic logs to a USB flash drive at the
next product start up.
The files can then be sent to HP to help determine the
problem.
Service Tools This item requires the service access code. If the product
does not reach the Ready state, use this item to print the
error logs. The logs can be copied to a USB storage
accessory when the product is initialized. Send these files
to HP to help troubleshoot the cause of the problem.
Reset Password Use this item to reset the administrator password.
Subsystems For manufacturing use only. Do not change these values.
Developer Tools Netexec
114 Chapter 2 Solve problems ENWW
To Next Page
Loading...