Table 2-62 Print modes
1
under the Adjust Paper Types submenu (continued)
Print Mode
(continued)
●
Rough
●
Heavy Rough
●
Opaque Film
●
Restore Modes
1
Not all print modes are available for all paper types.
Table 2-63 Print modes under the Optimize submenu
Normal Set to Smooth when printing on smooth paper of normal weight.
Heavy Paper Set to Smooth when printing on smooth, heavy media types.
Best Normal Enable this item to improve print quality of high toner coverage
print jobs when Plain or Any paper type is selected
CaCO3 Enable this item to reduce fuser contamination when using a
media that has a high calcium-carbonate content.
NOTE: Enabling this item will reduce the expected life span of
the fuser.
Envelope Control Set to Reduced Temp if envelopes are sticking due to moisture in
the envelop adhesive.
Environment Set to Low Temp if the product is operating in a low temperature
environment and is eperiencing problems with print quality, such
as blisters in the printed image.
Line Voltage Set to Low Voltage if the product is operating in a low-voltage
environment and is experiencing problems with print quality,
such as blisters in the printed image.
Tray 1 Set the mode to Alternate if marks appear on the back side of the
paper when printing from Tray 1. This sets the product to initiate
a clean sequence every time a job finishes when the product is set
for Any Size and Any Type for Tray 1.
Background Set to Alternate 1 when a background occurs all over the page.
Set to Alternate 2 when thin vertical lines appear on the page.
Set to Alternate 3 when the other alternatives do not correct the
problem.
Uniformity Control Set to Alternate 1 to improve uniformity on any paper type.
Set to Alternate 2 to improve uniformity on normal and light
paper types.
Set to Alternate 3 when the other alternatives do not correct the
problem.
Tracking Control Improves color stability by adjusting the bias voltage. Make sure
this mode is set to On.
Registration Set to Alternate when color misregistration occurs.
ENWW Use manual print modes 471
To Next Page
Loading...