5. Select Restart Now from the EWS confirmation page, or turn the product off, and then on again using
the power switch.
6. After the product reinitializes, print a configuration page and verify that the latest firmware version has
been installed.
USB flash drive (Pre-boot menu)
NOTE: Make sure that the USB port is enabled.
1. Copy the .bdl file to a portable USB flash drive.
2. Turn the product on.
3. The HP logo displays on the product control panel. When an underscore displays below the HP logo,
touch the logo to open the Pre-boot menu.
4. Touch the down arrow
button to highlight Administrator, and then touch the OK button.
5. Touch the down arrow
button to highlight Download, and then touch the OK button.
6. Insert the USB flash drive with the .bdl file on it.
NOTE: If the error message No USB Thumbdrive Files Found displays on the control-panel display,
connect the storage device to the external USB connection on the formatter or try using a different
portable storage device.
7. Touch the down arrow button to highlight USB Thumbdrive, and then touch the OK button.
8. Touch the down arrow
button to highlight the .bdl file, and then touch the OK button.
NOTE: The upgrade process can take up to 10 minutes to complete.
TIP: If there is more than one .bdl file on the storage device, make sure to select the correct file for
this product.
9. When the message Complete displays on the control-panel display, touch the back arrow button 3
times.
10. When the message Continue displays on the control-panel display, touch the OK button. The product
will initialize.
11. When the upgrade process is complete, print a configuration page and verify that the upgrade firmware
version was installed.
524 Chapter 2 Solve problems ENWW
To Next Page
Loading...