USB flash drive (control-panel menu)
1. Copy the .bdl file to a portable USB flash drive.
2. Turn the product on, and then wait until it reaches the Ready state.
3. From the Home screen on the product control panel, scroll to and touch the Device Maintenance button.
4. Touch the USB Firmware Upgrade button.
5. Insert the portable USB storage device with the .bdl file on it into the USB port on the front of the
product, and then touch the OK button.
6. Touch the .bdl file, and then touch the Upgrade button.
TIP: If there is more than one .bdl file on the storage device, make sure to select the correct file for
this product.
7. When the product prompts a upgrade confirmation, touch the Upgrade button.
When the upgrade is complete, the product will initialize.
NOTE: The upgrade process can take up to 10 minutes to complete.
8. When the upgrade process is complete, print a configuration page and verify that the upgrade firmware
version was installed.
ENWW Firmware upgrades 525
To Next Page
Loading...