EL-MF877-00 Page 3
Template Revision A
g. Cut 11 capacitors from the PCA, as shown in Figure 14.
POWER SUPPLY 3:
a. Using dikes, cut the two plastic cable clamps that secures the cables to the power supply cover (see Figure 15).
b. Using a phillips screwdriver, remove the six screws from the bottom that secure the cover to the power supply
chassis (see Figure 15).
NOTE: You do not need to remove the screws from the fan guard or the power connector.
c. Pull the cover off of the power supply.
d. Using dikes, cut all cables connected to the PCA in the power supply.
e. Remove the four screws that secure the power supply PCA to the chassis (see Figure 16).
f. Remove the power supply PCA from the power supply chassis.
g. Cut 6 capacitors from the PCA, as shown in Figure 17.
3.2 Optional Graphic. If the disassembly process is complex, insert a graphic illustration below to identify the items
contained in the product that require selective treatment (with descriptions and arrows identifying locations).
To Next Page
Loading...
