Display assembly
NOTE: The display assembly is spared at the subcomponent level only. For more display assembly
spare part information, see the individual removal subsections.
Before removing the display assembly, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4.
Remove the battery (see
Battery on page 34).
5. Disconnect the wireless antenna cables from the WLAN module (see
Memory module
on page 35).
6. Remove the following components:
a. Keyboard (see
Keyboard on page 38)
b. Hard drive (see
Hard drive on page 44)
c.
Top cover (see
Top cover on page 48)
Remove the display assembly:
1. Disconnect the display panel cable (1) from the system board.
66 Chapter 4 Removal and replacement procedures
To Next Page
Loading...
