Removal and replacement procedures
Maintenance and Service Guide 4–25
Ä
CAUTION: Support the display assembly when removing the following screws. Failure to support the display assembly can
result in damage to the display assembly and other computer components.
5. Remove the 4 Phillips PM2.5×7.0 screws 1 securing the display hinges to the computer.
6. Lift the display panel 2 straight up to remove it.
7. If it is necessary to replace the display bezel or any of the display assembly internal components, remove the
following screw covers and screws:
1 Two rubber screw covers on the display bezel bottom edge. The display rubber screw covers are included in
the Display Rubber Kit, spare part number 530999-001.
2 Two Phillips PM2.5×7.0 screws on the display bezel bottom edge.
To Next Page
Loading...
