DBPSK, DQPSK, CCK, OFDM
Security
1
Supports 64- and 128-bit WEP, WPA, WPA2, hardware-acceler
AES, 802.1x authentication types EAP-TLS, EAP-TTLS, PEAP-
PEAP-MSCHAPv2, LEAP, EAP-FAST.
Support for Cisco Security Features (proven compatibility with C
Aironet infrastructure products through the Cisco Compatible
Extensions Program).
Sub-channels
Multinational support with frequency bands and channels compli
local regulations.
Media Access Protocol
CSMA/CA (Collision Avoidance) with ACK
Network Architecture
Models
Ad-hoc (Peer to Peer)
Infrastructure (Access Point Required)
Roaming
IEEE 802.11 compliant roaming between access points.
Output Power
(for CKK)
2
16 dBm +/- 2 dB
Output Power
(for
OFDM; power varies by
data rate)
2
15 dBm +2/-5 dB
Power Consumption
Transmit: 1.8 Watts (max)
Receive: 1.4 Watts (max)
Idle mode: 75 mW (nominal)
Sleep mode: 60 mW
Power Management
ACPI compliant power management
802.11 Compliant Power Saving Mode
Receiver Sensitivity
3
54 Mbps: -72 dBm, 11 Mbps: -88 dBm , 1 Mbps: -97 dBm
Antenna type
High efficiency dual band antenna with polarization diversity, mo
in the display enclosure
Range
802.11 b – Typical
(@1 Mbps)
1200 feet – Outdoor Open Area
300 feet – Indoor, Office environment
802.11 g – Typical
(@1 Mbps)
1200 feet – Outdoor Open Area
300 feet – Indoor, Office environment
Form Factor
MiniPCI Type IIIB
Weight
0.026 lb (11.75 g) (max)
Dimensions
0.20 x 1.75 x 2.34 in (4.9 x 44.6 x 59.8 mm)
Operating Voltage
3.3v
Temperature
Operating
Non-operating
32° to 158° F (0° to 70° C)
-40° to 176° F (-40° to 80° C)
Humidity
Operating
Non-operating
10% to 90% (non-condensing)
5% to 95% (non-condensing)
Altitude
Operating
Non-operating
0 to 10,000 ft (3,048 m)
0 to 50,000 ft (15,240 m)
Configuration Utility
4
Choice of Configuration Utility:
z
Intel PROSet for Microsoft Windows 2000 or XP (require
Cisco Compatible Extensions support)
z
Microsoft Windows XP Wireless Network Connection Ma
1. Check latest software/driver release for updates on supported security features.
2. Maximum output power may vary by country according to local regulations.
3. Receiver sensitivity is measured at a packet error rate of 8% for 802.11b (CKK mod
and a packet error rate of 10% for 802.11a/g (OFDM modulation).
4. WLAN supplier's client utility is required for Cisco Compatible Extensions support.
may also be compatible with certain third-party software supplicants.
To Next Page
Loading...
