4 port Embedded SATA
controller
SATA Protocol
SATA 2, 3Gb/s
SATA Ports
4 internal
Port transfer rate
1.5 Gb/s total
Maximum Capacity
up to 2 TB (4 x 500GB non hot plug SATA HDD)
RAID Levels Supported
RAID 1+0 (Striping & Mirroring)
RAID 1 (Mirroring)
RAID 0 (Striping)
RAID 5 (Striping with parity)
Logical RAID Volumes
Supported
NOTE:
On SATA models with embedded RAID, setup instructions are
located in User Guide, CTO RAID is set-up not available. HP ProLiant
100 Series Server User Guide:
http://h20000.www2.hp.com/bc/docs/support/SupportManual/
c00368941/c00368941.pdf?jumpid=reg_R1002_USEN
HP 8 Internal Port SAS
Host Bus Adapter with
RAID
(SAS Model only)
Dimensions
(excluding
bracket)
6.6 x 2.5 x 0.6 in (16.8 x 6.4 x 1.6 cm)
Disk Drive and
Enclosure Protocol
Support
3 Gbps SAS (Serial Attached SCSI)
1.5 Gbps SATA (Serial Advanced Technology Attachment)
Architecture
64-bit
SAS Connectors
2 internal SFF8484 x4 Wide SAS Connectors
12 Gbps per x4 Wide SAS Port (4 x 3 Gbps)
Data Transfer Method
64-bit wide, PCI-X 133 MHz (1 GB/s maximum bandwidth)
PCI Bus Speed
PCI-X-133 and 3.3 volt PCI compatibility only
PCI
PCI-X and 3.3 volt PCI compatibility only
Simultaneous Drive
Transfer Ports
2 x4 Wide SAS Connectors
Port Transfer Rate
12 Gb/s per x4 Wide SAS Port (4 x 3 Gb/s)
Software upgradeable
Firmware
Yes
Maximum Capacity
576GB (8 x 72GB)
Memory Addressing
64-bit, supporting servers memory greater than 4 GB
Logical Drives
Supported
Up to 2 Logical Volumes
Up to 10 drives total in all RAID volumes
Up to 2 Drives per RAID 1
Up to 8 Drives per RAID 0
RAID Support
RAID 1 (Mirroring)
RAID 0 (Striping)
Upgradeable Firmware
4-MB flashable ROM
Disk Drive and
Enclosure Protocol
Support
3 Gbps SAS and 1.5 Gbps SATA
NOTE:
Slot 2 only supports standard PCI 32 bit add-on card due to proximity of the Heat Sink.
To Next Page
Loading...
