Delivery fan, cartridge fan, and environmental sensor
Before proceeding, remove the following components:
●
Left cover. See
Left cover on page 200.
Remove the delivery fan, cartridge fan, and environmental sensor
1. Remove five screws (callout 1), and then remove the sheet-metal plate (callout 2).
Figure 6-80 Remove the delivery fan, cartridge fan, and environmental sensor (1 of 9)
2
1
2. Disconnect five connectors (callout 3).
NOTE: Disconnect the larger connector on the right side from the bottom. Disconnect the two
smaller connectors on the right side from the top.
Figure 6-81 Remove the delivery fan, cartridge fan, and environmental sensor (2 of 9)
3
ENWW Internal assemblies 215
To Next Page
Loading...