Registration assembly
Before proceeding, remove the following components:
●
Secondary transfer assembly. See
Secondary transfer assembly on page 186.
●
Intermediate transfer belt (ITB). See
Intermediate transfer belt (ITB) on page 188.
●
Right-rear cover. See
Right-rear cover on page 198.
●
Left cover. See
Left cover on page 200.
●
Rear cover and upper-rear cover. See
Rear cover and upper-rear cover on page 209.
NOTE: It is not necessary to separate the upper-rear cover from the rear cover to remove the
registration assembly.
●
RD sensor assembly. See
Registration density (RD) sensor assembly on page 227.
TIP: Removing the RD sensor assembly makes it much easier to reinstall the registration
assembly.
●
Power-supply fan and fan duct. See
Power-supply fan and fan duct on page 230.
Remove the registration assembly
NOTE: If a replacement registration assembly is installed, you must use the control-panel menus to
reset the registration-roller count.
1. Remove two screws (callout 1).
Figure 6-111 Remove the registration assembly (1 of 8)
1
ENWW Internal assemblies 233
To Next Page
Loading...