2. Disconnect all the connectors.
Reinstallation tip The connector locations J124, J133, and J134 are not used.
Figure 6-123 Remove the DC controller PCA and tray (2 of 4)
3. Remove four screws (callout 3), and then remove the DC controller PCA.
Figure 6-124 Remove the DC controller PCA and tray (3 of 4)
3
NOTE: If removing the DC controller to access another component, skip this step and leave the
DC controller attached to the sheet-metal tray.
ENWW Internal assemblies 241
To Next Page
Loading...