4. Release one tab (callout 6), and then remove the fan and fan duct (callout 7).
Figure 6-147 Remove the cassette-pickup drive assembly (4 of 10)
6
7
5. Disconnect five connectors (callout 8; J110, J111 on the DC controller PCA), release the FFCs
from the guide (callout 9), and then release the wire harnesses from the guides.
NOTE: To locate DC controller connector locations, see DC controller connector locations
on page 167.
Figure 6-148 Remove the cassette-pickup drive assembly (5 of 10)
9
8
258 Chapter 6 Removal and replacement ENWW
To Next Page
Loading...