Cassette-pickup assembly
Before proceeding, remove the following components:
●
Formatter. See
Formatter PCA on page 175.
●
Right-rear cover. See
Right-rear cover on page 198.
●
Left cover. See
Left cover on page 200.
●
Rear cover and upper-rear cover. See
Rear cover and upper-rear cover on page 209.
NOTE: It is not necessary to separate the upper-rear cover from the rear cover to remove the
cassette-pickup assembly.
●
Registration assembly. See
Registration assembly on page 233.
●
Interconnect board (ICB). See
Interconnect board (ICB) on page 238.
TIP: For internal product access, you can remove the ICB and the low-voltage power supply as
a single component.
●
Low-voltage power supply. See
Low-voltage power supply on page 243.
●
High-voltage power supply lower. See
High-voltage power supply lower (HVPS-D) on page 248.
●
Cassette-pickup drive assembly. See
Cassette-pickup drive assembly on page 256.
Remove the cassette-pickup assembly
1. Release one tab (callout 1), and then remove the gear (callout 2).
Figure 6-157 Remove the cassette-pickup assembly (1 of 3)
2
1
ENWW Internal assemblies 263
To Next Page
Loading...