5. Remove two screws (callout 7). Use your finger to release the locking tab (callout 8), and then
remove the cover.
CAUTION: Be careful. The PGC actuators are easily dislodged when the cover is removed. See
Figure 6-179 Reinstall the PGC actuators (1 of 5) on page 276. To reinstall the actuators, see
Reinstall the protective glass cleaner (PGC) actuators on page 276.
Figure 6-176 Remove the laser/scanner assembly (C/Bk) (5 of 7)
7
8
6. Release one spring (callout 9).
CAUTION: The spring is not captive. Do not lose the spring when it is removed. Use a pair of
needle-nose pliers to safely retain the spring when it is removed. Do not use a flat blade screwdriver
to remove the spring; the spring could forcibly leave the product and strike you.
Reinstallation tip When you reinstall the spring, make sure that the laser/scanner fits tightly up
against the product chassis.
Figure 6-177 Remove the laser/scanner assembly (C/Bk) (6 of 7)
9
ENWW Internal assemblies 275
To Next Page
Loading...