5. Disconnect one connector (callout 7), remove two screws (callout 8), and then carefully lift the
assembly (callout 9) off of the product to remove it.
CAUTION: A solenoid arm (duplex models only; on the right side) and a spring (on the left side)
on the assembly are not captive. Do not lose the solenoid arm or spring when you remove the
assembly. If the solenoid arm or spring become dislodged, see
Reinstall the delivery assembly
on page 307.
Figure 6-222 Remove the delivery assembly (5 of 5)
7
9
8
306 Chapter 6 Removal and replacement ENWW
To Next Page
Loading...