2. If paper is visible, gently pull the jammed paper up or down to remove it.
3. Close the lower right door.
Jam causes and solutions
For locations of jam sensors, see Sensors on page 353.
Jams in the output bin
Table 7-14 Causes and solutions for delivery delay jam
Cause Solution
The output-bin media-full sensor lever is
damaged
Replace the paper delivery assembly. See Delivery assembly on page 303.
Poor contact of the output-bin media-full
sensor connector
Reconnect the connectors of the output bin full sensor (SR6) (J47) to DCC PCA
(J123).
The output-bin media-full sensor is defective Check the output bin full media sensor (SR6) by using the manual sensor test.
See
Manual sensor test (special-mode test) on page 325. Output bin full media
sensor is letter F in the sensor test. Toggle the sensor to determine if the value
changes for "F". If the value does not change, replace paper delivery assembly.
See
Delivery assembly on page 303.
Poor contact of the fuser-motor (M2)
connector
Reconnect the connectors of the fuser motor (J117), (J15), and the DC
controller PCA (J105).
The fuser (fixing) motor (M2) is defective Execute the fuser-motor driving test in the actuator-drive mode. If the motor is
defective, replace the fuser motor (M2).
ENWW Clear paper jams 415
To Next Page
Loading...