Item Sub-item Sub-item Values Description
lease exists, DHCP RELEASE and DHCP
RENEW menus are available to set DHCP
lease options.
Use AUTO IP for automatic link-local IPv4
addressing. An address in the form
169.254.x.x is assigned automatically.
If you set this option to MANUAL, use the
MANUAL SETTINGS menu to configure
TCP/IPv4 parameters.
MANUAL
SETTINGS
IP ADDRESS
SUBNET MASK
DEFAULT
GATEWAY
(Available only if CONFIG METHOD is set to
MANUAL) Configure parameters directly
from the product control panel:
IP ADDRESS: The unique IP address
(n.n.n.n) of the product, where n is a value
from 0 to 255.
SUBNET MASK: The subnet mask (n.n.n.n)
for the product, where n is a value from 0 to
255.
DEFAULT GATEWAY: The IP address of the
gateway or router used for communications
with other networks.
DEFAULT IP AUTO IP*
LEGACY
Specify the IP address to default to when the
print server is unable to obtain an IP address
from the network during a forced TCP/IP
reconfiguration (for example, when manually
configured to use BootP or DHCP).
NOTE: This feature assigns a static IP
address that might interfere with a managed
network.
AUTO IP: A link-local IP address 169.254.x.x
is set.
LEGACY: The address 192.0.0.192 is set,
consistent with older HP Jetdirect products.
DHCP RELEASE NO*
YES
This menu appears if CONFIG METHOD is
set to DHCP and a DHCP lease for the print
server exists.
NO: The current DHCP lease is saved.
YES: The current DHCP lease and the leased
IP address are released.
DHCP RENEW NO*
YES
This menu appears if CONFIG METHOD is
set to DHCP and a DHCP lease for the print
server exists.
NO: The print server does not request to
renew the DHCP lease.
YES: The print server requests to renew the
current DHCP lease.
Table 2-1 Embedded Jetdirect and EIO <X> Jetdirect menus (continued)
ENWW Configure device menu 33
To Next Page
Loading...