Item Sub-item Sub-item Values Description
PROXY PORT Type the port number used by the proxy
server for client support. The port number
identifies the port reserved for proxy activity
on your network, and can be a value from 0
to 65535.
IDLE TIMEOUT IDLE TIMEOUT: The time period, in seconds,
after which an idle TCP print data connection
is closed (default is 270 seconds, 0 disables
the timeout).
IPX/SPX ENABLE ON*
OFF
ON: Enable the IPX/SPX protocol.
OFF: Disable the IPX/SPX protocol.
FRAME TYPE AUTO*
EN_8023
EN_II
EN_8022
EN_SNAP
Selects the frame-type setting for your
network.
AUTO: Automatically sets and limits the
frame type to the first one detected.
EN_8023, EN_II, EN_8022, and EN_SNAP
are frame-type selections for Ethernet
networks
APPLETALK ENABLE ON*
OFF
Configures an AppleTalk network.
DLC/LLC ENABLE ON*
OFF
ON: Enable the DLC/LLC protocol.
OFF: Disable the DLC/LLC protocol.
SECURITY SECURE WEB HTTPS REQUIRED*
HTTPS OPTIONAL
For configuration management, specify
whether the embedded Web server will
accept communications using HTTPS
(Secure HTTP) only, or both HTTP and
HTTPS.
HTTPS REQUIRED: For secure, encrypted
communications, only HTTPS access is
accepted. The print server will appear as a
secure site.
HTTPS OPTIONAL: Access using either
HTTP or HTTPS is permitted.
IPSEC KEEP
DISABLE*
Specify the IPSec status on the print server.
KEEP: IPSec status remains the same as
currently configured.
DISABLE: IPSec operation on the print
server is disabled.
802.1X RESET
KEEP*
Specify whether the 802.1X settings on the
print server are reset to the factory defaults.
RESET: The 802.1X settings are reset to the
factor defaults.
KEEP: The current 802.1X settings are
maintained.
Table 2-1 Embedded Jetdirect and EIO <X> Jetdirect menus (continued)
ENWW Configure device menu 35
To Next Page
Loading...