HP Designjet 4500 Series - Page 60

2-30
System Error Codes
HP Designjet 4500 Printer Series Service Manual
System Error: 84.2:01
Internal Code: 0X1A060001
Problem
Description:
The printer tries to raise Roll 2 media to the level of the Drive Roller, but the
Main Media sensor cannot detect the presence of the media
Corrective Action: Try the following:
 Make sure there is no media jammed in the Roll 2 media path.
 Check that the Main Media Sensor cable is not damaged and is
connected correctly to the Interconnect PCA
.
 Perform the Sensor Test ⇒ Page 4-39.
 Replace the Media Sensor ⇒ Page 8-115.
System Error:
84.2:01
Internal Code: 0X1A060002
Problem
Description:
The printer tries to remove Roll 2 media from the area of the driver roller, but
the Main Media sensor detects the presence of media.
Corrective Action: Try the following:
 Make sure there is no media jammed in the Roll 2 media path.
 Check that the Main Media Sensor cable is not damaged and is
connected correctly to the Interconnect PCA
.
 If very long media is in the printer path, more than A0, the printer will
display this error, in this case manually unload the media from the printer.
 Perform the Sensor Test ⇒ Page 4-39.
 Replace the Main Media Sensor ⇒ Page 8-115.
System Error:
84.2:01
Internal Code: 0X1A060003
Problem
Description:
The printer tries to raise Roll 2 media to the level of the Roll 2 Sensor, but the
sensor cannot detect the presence of the media.
Corrective Action: Try the following:
 Make sure the media has not slipped from the Roll 2 media path.
 Check that the Roll 2 Sensor cable is not damaged and is connected
correctly to the Interconnect PCA
.
 Perform the Sensor Test ⇒ Page 4-39.
 Replace the Roll 2 Media Sensor ⇒ Page 8-232.
System Error:
84.2:01
Internal Code: 0X1A060004
Problem
Description:
The printer fails to remove media from the Roll 2 media path.
Corrective Action: Try the following:
 Make sure the media is in position in the Roll 2 media path.