HP Designjet 4500 Series - Page 61

2-31
System Error Codes
HP Designjet 4500 Printer Series Service Manual
 Check that the Roll 2 Sensor cable is not damaged and is connected
correctly to the Interconnect PCA
.
 Perform the Sensor Test ⇒ Page 4-39.
 Replace the Roll 2 Media Sensor ⇒ Page 8-232.
System Error:
84.2:01
Internal Code: 0X1A060005
Problem
Description:
The BT Arm cannot reach the working position.
Corrective Action: Try the following:
 Make sure the media spindle in the Roll 1 Module is turning.
 Perform the Media Drive Test ⇒ Page 4-12.
 Replace the Roll 2 BT Arm Encoder Disc ⇒ Page 8-223.
 Replace the BT Arm ⇒ Page 8-197.
System Error:
84.2:01
Internal Code: 0X1A060006
Problem
Description:
The BT Arm has stalled.
Corrective Action: Try the following:
 Make sure there is no media jammed in the Roll 2 media path.
 Perform the Media Drive Test ⇒ Page 4-12.
 Replace the Roll 2 BT Arm Encoder Disc ⇒ Page 8-223.
 Replace the BT Arm ⇒ Page 8-197.
System Error:
84.2:01
Internal Code: 0X1A060007
Problem
Description:
The Roll 2 Media Sensor has detected media when there should not be any.
Corrective Action: Try the following:
 Make sure there is no media jammed in the Roll 2 media path.
 Switch the Power OFF from the back of the Printer and disconnect the
Power cord. Reconnect the power cord and power On the Printer.
 Perform the Sensors Test ⇒ Page 4-39.
 Replace the Roll 2 Media Sensor ⇒ Page 8-232.
System Error:
84.2:01
Internal Code: 0X1A060008
Problem
Description:
The printer is in the process of loading media and there is already media