Why is my HP Laptop battery not charging?
If the main battery of your HP Laptop isn't charging, verify the power source and ensure the battery is properly installed and the contacts are clean. If possible, test with another battery and AC adapter. Also, move the laptop away from heat sources, unplug the AC adapter to let the battery cool, and check for any blocked air vents.
How to fix sluggish startup on HP DesignJet 500 Laptop?
If your HP Laptop experiences sluggish startup or shutdown times, run ScanDisk and Disk Defragmenter to check and optimize the hard drive. Also, delete any temporary and unneeded files.
Why HP Laptop does not boot on battery but works on AC?
If your HP Laptop does not boot on the main battery but boots on AC power, check the battery level using the battery LEDs and inspect the battery contacts. If you have access to another battery, try using it to see if the problem is with the original battery.
How to fix no sound on HP Laptop?
If no sound is audible on your HP Laptop, increase the sound volume using Fn+UP ARROW, the volume control, and software controls. Ensure that sound is enabled via the audio-off button and software settings. Also, check for sound resource conflicts in Device Manager.
How to make HP Laptop boot from CD/DVD?
If your HP Laptop does not boot from a CD or DVD, ensure that the CD or DVD is bootable. Check the boot order in BIOS Setup. Restart the computer. You can also test the DVD drive using the e-DiagTools diagnostics.
What to do if HP DesignJet 500 does not respond to undock switch?
If your HP Laptop does not respond to the undock switch or Eject command, check the power sources. Use the emergency undock latch. If the computer is not fully docked, use the emergency undock latch. Reset the computer and the expansion base. Test the expansion base with e-DiagTools diagnostics.
Why secondary battery module does not charge on HP DesignJet 500?
If the secondary battery module in your HP Laptop does not charge, ensure the main battery is fully charged first, as the secondary battery won't charge otherwise. Also, check the power source and make sure the secondary battery is properly installed.
How to fix HP DesignJet 500 that does not boot on AC or battery?
If your HP Laptop doesn't boot on AC power or battery, check the power source. Try pressing the system-off switch to reset the computer. As an alternative, unplug the AC adapter, remove all batteries, and then reconnect the power.
What to do if HP DesignJet 500 shows 'Invalid system disk' error?
If you receive an error message like “Invalid system disk” or “Auto IDE error” on your HP Laptop, first check for a disk in the floppy drive. Then, check the boot order in BIOS Setup. If the issue persists, remove and reinsert the hard drive.
What to do if hard disk doesn’t spin in HP DesignJet 500?
If the hard disk in your HP Laptop isn't spinning, check the power source. Remove and reinsert the hard drive. Use a flashlight to inspect the connector.
To Next Page
General