the output contains only a
partial print
hp designjet
5500 series
welcome
how do I ...
tell me about ...
the problem is ...
legal notices
glossary
index
● Did you press Cancel before all the data were received by the printer?
If so, you have ended the data transmission and will have to print the
page again.
● The I/O Time-out setting may be too short. From the front panel, you
can increase the I/O Time-out setting to a longer period and then send
the print again. Choose the
icon, then I/O Setup > I/O Timeout.
● There may be a communications problem between your computer and
the printer. Check your interface cable.
● Check to make sure that your software settings are correct for your
current page size (e.g. long-axis prints).
● If you are using network software, make sure it has not timed out.
© 2002 hewlett-packard company
file:///C|/Documents%20and%20Settings/---/Desktop/HP/html/p0105b.htm [8/5/2002 3:36:35 PM]
To Next Page
Loading...