208 Chapter 4 Service Tests, Utilities & Calibrations
Tests, Utilities & Calibrations
Procedure
1. Go to Service Menu >5. Service Calibration Menu>5.3 Substrate Path Menu>5.3.2 OMAS Calibra-
tion.
2. When the following message displays on the front panel, select the OK key.
3. If media is already loaded, the following message displays on the front panel and the media is
unloaded.
4. If the media cannot be unloaded automatically, the Front Panel will show the following message.
5. Follow the instructions and unload the media.
6. The Front Panel prompts you to load media.
• Raise the Media Lever.
• Load the media.
• Lower the medial lever.
NOTE: During this calibration process you have to load the media with the Carriage
positioned in the print path.
To Next Page
Loading...