Service Menu 209
Tests, Utilities & Calibrations
7. Select the media (HP Paper Aqueous).
8. The media calibration process starts and front panel shows the following messages:
• Calibrating paper advance.
• Trimming roll edge. Please wait.
9. The Front Panel then prompt you to unroll 1 meter of media to avoid back tension. Unroll 1 meter of
media and press OK.
10. The Printer will start to print the OMAS Calibration Pattern. This could take several minutes during
which the following message will be displayed on the Front Panel.
11. Once the OMAS Calibration Pattern has been printed successfully, the following message will be
displayed on the Front panel. Press the OK key to continue.
If the OMAS Calibration fails for any reason, a warning message will display on the Front Panel. In
this case, try the following:
• Retry the Paper Advance Calibration.
NOTE: Remove the pattern from the printer and leave it to dry for a few minutes before
continuing with the Calibration.
NOTE: MAKE SURE MEDIA IS NOT LOADED INTO THE PRINTER BEFORE STARTING TO
SCAN THE OMAS CALIBRATION PATTERN.
To Next Page
Loading...