Service Menu 215
Tests, Utilities & Calibrations
5. The Printer will start to calibrate the Line Sensor. Once the Line Sensor has been calibrated, the
results will be displayed on the Front Panel. Press OK to continue or press Back or Cancel to exit
the calibration.
If the values are not within the range specified, an error will display on the Front Panel. In this case,
try the following:
• Try the Scan-Axis Calibration again.
• Replace the Line Sensor ⇒ page 486.
6. The Printer will start to calibrate the Line Sensor position to the Black Printhead. It will print a line of
black dots and then scan them:
7. Once the Line Sensor has been calibrated, the results will be displayed on the Front Panel. Press OK
to finish the calibration or press Back or Cancel to exit the calibration.
8. The Printer will now perform the Printhead Alignment.
To Next Page
Loading...