HP Designjet L25500 Printer series - Page 370

364 Chapter 8 Removal & Installation
Removal & Installation
Service Station
Removal
1. Remove the Right Cover ⇒ See page 319 .
2. Primer Assembly ⇒ See page 355.
3. Primer Valves ⇒ See page 357.
4. Remove the Drop Detector ⇒ See page 377.
5. Remove the Printhead Maintenance Cartridge ⇒ See
the User’s Guide.
6. Remove one T-25 screw that secures the end section of
the Drain Tube above the Printhead Maintenance
Container.
7. Remove one T-20 screw that secures the middle section
of the Drain Tube to the rear of the Printer.
WARNING!: Switch off the printer and remove the power cable.