Service Station 367
Removal & Installation
16. Remove two T-15 screws (Type J) that secure the
Service Station to the Chassis.
17. Remove the Service Station from the Printer.
• Reset “4.7.5 Service Station cycle counter”
⇒
page 201.
CAUTION: When removing the screws, be
very careful NOT to damage the Encoder Strip.
CAUTION: When removing the screws that
secure the Service Station to the X-Axis, hold
the Service station as it could fall when the
screws are removed.
NOTE: After installing the NEW Service
Station, make sure you perform the following
Service Utility:
To Next Page
Loading...