Aerosol Fan and Filter 373
Removal & Installation
Aerosol Fan and Filter
Removal
1. Remove the Right Cover
⇒
See page 319
.
2. Remove the Rear Cover ⇒ See page 332.
3. Remove the Right Connector Cover
⇒
See page 341.
4. Remove the Service Station
⇒
See page 364
5. From underneath the Service Station: Remove two T-15
screws (Type G) that secure the Aerosol Fan to the
Service Station.
6. From underneath the Service Station: Remove two T-15
screws (Type G) that secure the Aerosol Fan to the
Service Station.
WARNING!: Switch off the printer and remove the power cable.
To Next Page
Loading...