418 Chapter 8 Removal & Installation
Removal & Installation
Belt Assembly
Removal
1. Remove the Right Cover
⇒
See page 319
.
2. Remove the Left Cover
⇒
See page 325.
3. Remove the Top Cover
⇒
See page 334
.
4. Remove the Encoder Strip
⇒
See page 399
.
5. Remove the Carriage Assembly
⇒
See page 408
.
6. Release the Belt from the bottom of the Carriage
Assembly.
• Reset the life counter “4.5.1 Reset belt cycles
⇒
See
page 200.
WARNING!: Switch off the printer and remove the power cable.
NOTE: After installing the NEW Belt
Assembly, make sure you perform the following
Service Utility:
To Next Page
Loading...