Scan-Axis Motor 419
Removal & Installation
Scan-Axis Motor
Removal
1. Remove the Right Cover
⇒
See page 319
.
2. Remove the Left Cover
⇒
See page 325.
3. Remove:
• For the 42-inch model, the Left Connector Cover
⇒ See page 343.
• For the 60-inch model, the Electronics Module
Extension⇒ See page 344.
4. Uncap the Carriage Assembly by manually pulling out
the Printhead Maintenance Cartridge tray.
5. Lift the Primer and hold the Primer to its maximum
position to avoid damaging it when you move the
Carriage Assembly in the next step.
WARNING!: Switch off the printer and remove the power cable.
To Next Page
Loading...