HP Designjet L25500 Printer series - Page 579

Drive Roller 573
Removal & Installation
Drive Roller
Removal
1. Remove the Right Cover ⇒ See page 319 .
2. Remove the Left Cover ⇒ See page 325.
3. Remove the Right Connector Cover ⇒ See page 341.
4. Remove:
• For the 42-inch model, the Left Connector Cover
⇒ See page 343.
• For the 60-inch model, the Electronics Module
Extension⇒ See page 344.
5. Remove the Service Station ⇒ See page 364.
6. Remove the Ink Supply Station ⇒ See page 388.
7. Remove the Media-Axis Motor ⇒ See page 422.
8. Remove the Encoder Disc and Sensor ⇒ See
page 557.
9. Remove the Media Lever Assembly ⇒ See page 560.
10. Remove the Media Sensor ⇒ See page 563.
11. Remove the Center Guide ⇒ See page 571.
12. Remove two T-10 screws that secure the Drive Roller
Gear.
13 . Remove the Drive Roller Gear from the Printer.
WARNING!: Switch off the printer and remove the power cable.