580 Chapter 8 Removal & Installation
Removal & Installation
Left Rollfeed Module Assembly
Removal
1. Remove the Left Cover
⇒
See page 325
.
2. Remove the Ink Supply Station
⇒
See page 388.
3. Remove the Input Roller
⇒
See page 550.
4. Remove the APS Assembly
⇒
See page 395.
5. Remove the Media Spindle (if installed).
6. Remove one T-15 screw that secures the APS Mounting
Plate to the Printer.
7. Tilt out the top of the APS Mounting Plate support.
8. Remove the APS Mounting Plate support from the
Printer.
WARNING!: Switch off the printer and remove the power cable.
To Next Page
Loading...