HP DesignJet Series - Page 173

7-41
Removal and Installation
HP Designjet Ultra Low End Printer Service Manual
Carriage Belt
Removal
Switch off the product and remove the power cable.
1. Remove the Center Cover
⇒ Page 7-7
2. Remove the Right End Cover ⇒ Page 7-9 .
3. Remove the Electronics Module ⇒ Page 7-18.
4. Remove the Power Supply Unit ⇒ Page 7-22.
5. Remove the Service Station ⇒ Page 7-24.
6. Remove the Ink Supply Tubes ⇒ Page 7-32.
7. Remove the Carriage Assembly ⇒ Page 7-35.
8. Release the Belt from the bottom of the
Carriage Assembly.