7-42
Removal and Installation
HP Designjet Ultra Low End Printer Service Manual
Starwheel Assembly (Applicability: 10ps, 20ps, 30, 30n,
50ps)
Removal
Switch off the product and remove the power cable.
1. Remove the Center Cover
⇒
Page 7-7.
2. Remove 1 T-10 screw (Type A) that
secures the Starwheel Assembly to the right
hand side of the printer.
3. Remove 1 T-10 screw (Typ
e A) that
secures the Starwheel Assembly to the left
hand side of the printer.
4. Remove the Starwheel Assembly.
To Next Page
Loading...