7-43
Removal and Installation
HP Designjet Ultra Low End Printer Service Manual
Starwheel Assembly
Removal
Switch off the product and remove the power cable.
1. Remove the Center Cover
⇒
Page 7-7.
2. Remove the Right End Cover
⇒
Page 7-9
.
3. Remove the Left End Cover
⇒
Page 7-11
.
4. Remove 1 T-10 screw that secures the
St
arwheel Assembly to the right hand side
of the printer.
5.
Remove 2 T-10 screws that secure the
Starwheel Assembly to the left hand side of
the printer.
6.
Remove the Starwheel Assembly.
To Next Page
Loading...