HP Designjet T Series — Service Manual 2-21
System Error Codes - Full Descriptions
3 Check that the Printer has the latest Firmware version. If not, update the
Firmware to the latest version.
4 Perform the Carriage Test to troubleshoot the problem further. See 4.
Carriage Assembly on page 3-26.
5 If
the System Error continues, replace the Line Sensor. See Line Sensor
(T1100/T1100ps/T610) on page 6-152 or Line Sensor (T1120/T1120ps)
on page 6-157.
System Error:
61:YZ
Problem
Description:
The file format is incorrect and the Printer cannot process the job.
Corrective Action: Try the following:
1 S
witch the Power OFF from the back of the Printer and disconnect the Power
cord. Reconnect the power cord and power On the Printer.
2 Chec
k the graphic language setting of the Printer (Refer to the User's Guide).
3 R
esend the file to the printer.
4 C
heck that the Printer has the latest Firmware version. If not, update the
Firmware to the latest version.
5 T
he PostScript™ fonts are missing. Upgrading the Firmware will re-install the
fonts.
6 T
he file cannot be printed because it is password protected. Resend the file
without password protection.
System Error:
63:YZ
Problem
Description:
Input/Output problem through the network interface of the Formatter.
Corrective Action: Try the following:
1 S
witch the Power OFF from the back of the Printer and disconnect the Power
cord. Reconnect the power cord and power On the Printer.
2 C
heck that the Network cable is correctly connected to the Formatter.
3 C
heck that the Printer has the latest Firmware version. If not, update the
Firmware to the latest version.
4 If
the System Error continues, replace the Formatter. See Formatter on page
6-200.
System Error:
64:YZ
Problem
Description:
Input/Output problem through the USB Port.
Corrective Action: Try the following:
1 S
witch the Power OFF from the back of the Printer and disconnect the Power
cord. Reconnect the power cord and power On the Printer.
2 C
heck that the USB cable is correctly connected to the Printer.