HP Designjet T Series — Service Manual 2-31
System Error Codes - Full Descriptions
2 Perform the Media Drive diagnostic test to troubleshoot the problem further.
See
2. Paper Drive on page 3-18.
3 If
the printer has a 44 inch scan axis (and a Rewinder), perform the
Rewinder diagnostic test to troubleshoot the problem further. See
6.
Rewinder on page 3-34.
4 Chec
k the connections on the Main PCA; the Media Advance Drive is
connected to the connector labeled Paper Motor.
5 A
djust the encoder disc and motor mount configuration using the Media
Advance Drive installation instructions. See
Media Advance Drive on page
6-218.
6 If the S
ystem Error continues, replace the Media Advance Drive. See Media
Advance Drive on page 6-218.
System Error:
84:YZ
Problem
Description:
Back tension servo shutdown (roll feeding).
Corrective Action: Try the following:
1 S
witch the Power OFF from the back of the Printer and disconnect the Power
cord. Reconnect the power cord and power On the Printer.
2 If
the problem persists, contact HP support.
System Error:
85:YZ
Problem
Description:
Problem finding the Drive Roller zero.
Corrective Action: Try the following:
1 P
erform the Media Drive diagnostic test to troubleshoot the problem further.
See
2. Paper Drive on page 3-18.
2 If the S
ystem Error continues, replace the Encoder Disk and Encoder Sensor.
See
Encoder Disk and Encoder Sensor on page 6-216.
System Error:
86:YZ
Problem
Description:
Possible Paper Jam.
Corrective Action: Try the following:
1 S
witch the Power OFF from the back of the Printer and disconnect the Power
cord. Reconnect the power cord and power On the Printer.
2 Op
en the Window and check for any visible obstacles restricting the
movement of the Drive Roller. If there is a wrinkled mass of media inside the
paper path, lift the Pinch wheels (using the Media Lever) and clear the
obstruction.
To Next Page
Loading...