10. Lower then lift the Vacuum Fan out of its attachment.
11. Remove the Vacuum Fan from the printer.
Installation
When connecting the Vacuum Fan cables to the Interconnect PCA, make sure you connect the
cable with the label marked Vacuum Fan 1 to connector 1 and the cable with the label marked
Vacuum Fan 2 to connector 2. You can check if both cables are labelled correctly by the actual
markings on the Vacuum Fan.
Make sure that the OMAS ribbon cable is free of slack when you install the cable clamp.
After installing the new Vacuum Fan, make sure you perform Paper-advance Calibration
Paper-
advance calibration on page 124.
Vacuum Fan Cable
Removal
WARNING! Switch off the printer and remove the power cable.
1. Remove the Right Cover See Cover, Right on page 224.
2. Remove the Right Connector Cover
See Connector Cover, Right on page 236.
3. Remove the Right Smart Roll-loading System Cover
See Smart Roll-loading System Cover, Right
on page 258.
ENWW
Disassembly order
251
To Next Page
Loading...