NOTE: Make sure you take note of the positions of the Foams located underneath the center Platen.
NOTE: When reinstalling the parts, make sure you apply the grease (included with the support part) to the
gears.
NOTE: After installing the new Center Platen, make sure you perform the following Service Calibration:
●
Paper-advance Calibration
Paper-advance calibration on page 115.
NOTE: To simplify the installation of the OMAS an Attachment Screw Retainer has been added to hold the
two T-20 attachment screws. This part is delivered with the Center Platen in case either of the OMAS
attachment screws are completely removed during the removal of the Center Platen.
OMAS Attachment Screws Completely Removed during Center Platen Removal
1. Completely remove OMAS from the printer
See Optical Media Advance Sensor (OMAS) on page 340.
2. Install the Center Platen.
NOTE: When reinstalling the parts, make sure you apply the grease (included with the support part) to
the gears.
382 Chapter 9 Printer part removal and installation ENWW
To Next Page
Loading...