6. Ensure the end of the blue handle catches the wire loop on the near side of the carriage.
7. Lower the handle to rest on the carriage cover.
When all the printheads have been inserted correctly and are accepted by the printer, the printer beeps.
NOTE: If the printer does not beep when you insert the printhead and the Replace message appears
on the front-panel display, the printhead may need to be reinserted.
8. Close the window.
9. The front-panel display conrms that all printheads are correctly inserted. The printer starts checking
and preparing the printheads. The default routine process, when all printheads are changed, takes 20
minutes. If the printer nds problems in preparing the printheads, it takes longer, up to 45 minutes. For a
single printhead insertion, the times vary between 2 and 40 minutes. After all printheads are checked
and prepared, the printhead realignment procedure runs automatically if paper is loaded, see Align the
printheads on page 153.
10. You are recommended to perform a color calibration after inserting a new printhead. See Color
calibration on page 74.
110 Chapter 13 Handling ink cartridges and printheads ENWW
To Next Page
Loading...