Continuable and Non-Continuable Error Codes 63
System Error Codes
• Switch the Power OFF from the back of the Printer and disconnect the Power cord. Reconnect the
power cord and power On the Printer.
• Clean the Encoder Strip ⇒ Page 454
• Replace the Primer Assembly ⇒ Page 294.
System Error:
50:01
Problem Description:
OMAS Navigation failure.
Corrective Action:
Try the following:
• Switch the Power OFF from the back of the Printer and disconnect the Power cord. Reconnect the
power cord and power On the Printer.
• Clean the OMAS window (CREF to procedure in Chap 9)
• Replace the OMAS Module ⇒ Page 351.
System Error:
50:03
Problem Description:
FW error in DSP or Engine code or link is broken between PCAs.
Corrective Action:
Try the following:
• There is a tendancy for this system error to being displayed because of cables becoming
disconnected. Check all relavant cables are correctly connected, especially the cables from the
OMAS Controller and the Main PCA and the Sausalito PCA.
• Switch the Power OFF from the back of the Printer and disconnect the Power cord. Reconnect the
power cord and power On the Printer.
• Check that the Printer has the correct type of Main PCA is installed, Designjet Z6100 NOT Designjet
4x00.
• Check that the Printer has the latest Firmware version. If not, update the Firmware to the latest
version.
• Replace the OMAS Controller Card ⇒ Page 362
• Replace the OMAS Module ⇒ Page 351
System Error:
50.1:10
Problem Description:
Error with the media advance Sensor component or with the cable between sensor and controller.
Corrective Action:
Try the following:
To Next Page
Loading...