4.
Insert all of the other printheads that need to be installed, and close the carriage
cover.
Make sure that the end of the blue handle catches the wire loop on the near
side of the carriage.
5.
Lower the handle to rest on the carriage cover.
When all of the printheads have been inserted correctly and the printer has
accepted them, the printer beeps.
NOTE: If the printer does not beep when you insert the printhead and
the Replace message appears on the front-panel display, you might
need to reinsert the printhead.
Insert a printhead
33
Handle the ink
To Next Page
Loading...
