HP Designjet Z6200 - Page 65

SE 29:01
Cause: Maintenance Cartridge not inserted correctly
Solution: Try the following:
●
Open the Maintenance Cartridge door on the right-hand side of the printer, make sure that the
maintenance cartridge is correctly seated, then close the door.
●
If the problem persists, replace the Maintenance Cartridge.
SE 29:02
Cause: Ink Absorber almost full
Solution: Replace the Ink Absorber.
SE 32:01
Cause: Take-up Reel (TUR) communication failure
Solution: Try the following:
●
If you want to continue using the TUR, turn off the printer and check that all TUR cables are
connected (sensor cables, printer cable).
●
If not, you may need to unload the paper from the TUR manually. Remember to cut the paper first
(either manually or by pressing the Form Feed and Cut key).
SE 32:01.1
Cause: Take-up Reel (TUR) early paper jam
Solution: Try the following:
●
Check there is no obstacle between the Take-up reel optical sensors.
●
Check the paper is attached to the TUR spindle.
●
Check the TUR switch is in the correct position.
●
If needed, use the TUR arrow keys to wind paper before resume printing.
●
To resume printing, press OK.
SE 32:01.2
Cause: Take-up Reel (TUR) paper jam
Solution: Try the following:
●
Check that there is no interference around the TUR optical sensors.
●
Check the paper is attached to the TUR spindle.
●
Check the TUR switch is in the correct position.
●
Check there is no obstacle between the TUR optical sensors.
ENWW
Continuable and non-continuable error codes
55
System error codes