HP Designjet Z6200 - Page 66

●
If required, use the TUR arrow keys to wind paper before resuming the print.
●
When the jam is cleared, printing is resumed. Press the OK key to clear the warning message.
SE 32:01.9
Cause: Take-up Reel (TUR) disabled because paper was removed unexpectedly
Solution: Remove all paper from the printer and reinstall the TUR.
SE 32:02
Cause: Take-up Reel (TUR) not detected or disconnected while printer was off
Solution: Connect the TUR to the printer and press OK to continue.
SE 36.0:01
Cause: Duplexer communication error
Solution: Try the following:
●
Reseat the cables between the Duplexer and the printer.
●
Uninstall and reinstall the Duplexer.
●
If the problem persists, contact the manufacturer of the Duplexer.
SE 36.01:01
Cause: Duplexer paper skew error
Solution: Try the following:
●
Unload the paper and try again.
●
If the problem persists, uninstall and reinstall the Duplexer. Make sure that the printer and the
Duplexer paper path are well aligned and that there are no obstacles in between.
SE 36.02:01
Cause: Duplexer paper incorrect lateral edge position
Solution: Try the following:
●
Unload the paper and try again.
●
If the problem persists, uninstall and reinstall the Duplexer. Make sure that the printer and the
Duplexer paper path are well aligned and that there are no obstacles in between.
SE 36.03:01
Cause: Duplexer unable to detect paper
56 Chapter 2 System error codes ENWW
System error codes