HP Designjet Z6200 - Page 68

SE 43:01
Cause: Vacuum Fan spinning at wrong speed
Solution: Try the following:
●
Turn the power off at the rear of the printer and disconnect the power cord. Reconnect the power
cord and turn on the printer.
●
If the system error persists, replace the Vacuum Fan
Vacuum Fan on page 257.
SE 43:10
Cause: Vacuum Fan failure
Solution: Try the following:
●
Turn the power off at the rear of the printer and disconnect the power cord. Reconnect the power
cord and turn on the printer.
●
Check that the Vacuum Fan cable is not damaged and is correctly connected to the Vacuum Driver
PCA and to both Vacuum Motors.
●
Check that the Interconnect to Vacuum Driver cable is not damaged and correctly connected to
Vacuum Driver PCA and to the Interconnect PCA.
●
Replace the Vacuum Fan
Vacuum Fan on page 257.
SE 43.1:10
Cause: Vacuum Driver PCA communication or hardware failure
Solution: Try the following:
●
Turn the power off at the rear of the printer and disconnect the power cord. Reconnect the power
cord and turn on the printer.
●
If the system error persists, replace the Vacuum Fan
Vacuum Fan on page 257.
SE 43:11
Cause: Vacuum Fan PCA cable does not seem to be connected
Solution: Try the following:
●
Check that the Interconnect PCA to Vacuum Driver cable is not damaged.
●
Check that the Interconnect PCA to Vacuum Driver cable is correctly connected to the Interconnect
PCA and the Vacuum Fan PCA.
●
If the problem persists, replace the Interconnect PCA to Vacuum Driver cable.
SE 44.1:10
Cause: Left Aerosol Fan stopped
58 Chapter 2 System error codes ENWW
System error codes